Pruning clematis


So much for New Year's resolutions ...

The other day, I was cleaning up the garden and the day's project was to prune several Clematis. If you have some of your own, you know that there are three Groups (A - those flowering in early Spring on the previous season's growth, B - those flowering on previous season's growth and then again later in the season on current year's growth, and C - those that produce flowers on current year's growth each year). Some authors even refer to a fourth Group. In any case, each Group is supposed to be pruned differently.

I have found though that if you forget what Group your Clematis belongs to, the plant itself will show you where to prune. I have a C. terniflora that in mid-May begins to produce leaves as high as 6 feet above ground level. That's where I prune. Two others, C. texensis 'Dutchess of Albany' and C. x durandii, usually are leafing out at between 2 and 3 feet above ground level. That's where I prune.

Yes I know, all three Clematis belong to Group C and 30 inches is about where they should be pruned but I prune the terniflora much higher. If you are not sure whether you have a Group B or C Clematis, you will be OK if you prune 30 inches or higher.

Group A can be problematic though as it should be pruned after flowering in the Spring but no later than July as you want it to have enough new growth before Winter to flower again in the Spring. That may be where I went wrong with my C. macropetala and why I no longer have it.
Comments
See Older Posts...